|
|
Etching Tank - I
I built an etching tank to meet my needs in producing printed circuit boards
Date: 04/10/2008
Views: 30
|
|
|
|
Etching Tank - II
I built the etching tank from acrylic sheet.
Date: 04/10/2008
Views: 36
|
|
|
|
Etching Tank - III
The piece that will form the sides and bottom is clamped on the mandrel
Date: 04/10/2008
Views: 32
|
|
|
|
Etching Tank - IV
The first bend has been made
Date: 04/10/2008
Views: 33
|
|
|
|
Etching Tank - V
The sides and bottom with the PC board support fastened on the bottom
Date: 04/10/2008
Views: 38
|
|
|
|
PC board Support
This piece of acrylic was fashioned to hold the boards vertical in the tank
Date: 04/10/2008
Views: 30
|
|
|
|
Etching Tank - IV
The tank's ends were welded to the sides using solvent
Date: 04/10/2008
Views: 32
|
|
|
|
Etching Tank - VII
Testing the tank
Date: 04/10/2008
Views: 33
|
|
|
|
Etching Circuit Boards - I
A view of a board in place ready to etch
Date: 04/10/2008
Views: 29
|
|
|
|
Etching Circuit Boards - II
An etching in progress.
Date: 04/10/2008
Views: 34
|
|
